P22FD — NOx sensor slow response high to low, bank 1 sensor 2
| Meaning | The control unit detected that the NOx sensor downstream of the SCR (sensor 2, bank 1) is slow to show a drop in nitrogen oxides. The value stays high longer than normal. The check on SCR system efficiency loses reliability. |
| Family | Powertrain (P) |
Typical symptoms
Messages about AdBlue or emissions
Irregular AdBlue consumption
Possible power reduction
Failed emissions inspection
Common causes
Deposits on the sensing element
Exhaust leak near the sensor
Connector or wiring with a faulty contact
Faulty sensor module
What to do
How to read code P22FD
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22FD starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (FD) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22FD mean?
NOx sensor slow response high to low, bank 1 sensor 2. The control unit detected that the NOx sensor downstream of the SCR (sensor 2, bank 1) is slow to show a drop in nitrogen oxides. The value stays high longer than normal. The check on SCR system efficiency loses reliability.
Can I keep driving with code P22FD active?
With caution: limp mode possible, have it checked soon
Common causes — P22FD
Worn downstream NOx sensor Deposits on the sensing element Exhaust leak near the sensor Connector or wiring with a faulty contact Faulty sensor module
How do you fix code P22FD?
Have the sensor checked with the diagnostic tool, together with wiring and exhaust sealing. You don't need to stop right away, but it shouldn't be put off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22FC — NOx sensor slow response low to high, bank 1 senso...
- Next code: P22FE — NOx sensor sensing element, bank 1 sensor 2
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3