P22FF — SCR catalyst inlet temperature too low
| Meaning | The control unit detected that the exhaust gas at the SCR catalyst inlet is too cold for the AdBlue system to work properly. Below a certain temperature, dosing cannot take place or is not effective. It can be a result of how the car is used, but also of a fault. |
| Family | Powertrain (P) |
Typical symptoms
Dashboard warnings about AdBlue or emissions
Higher nitrogen oxide emissions
AdBlue dosing suspended or reduced
Possible power limitation if the fault persists
Common causes
Faulty exhaust temperature sensor
Exhaust leak before the SCR
Engine thermal management problems, such as thermostat or EGR system
Damaged exhaust insulation or components
Very cold weather
What to do
How to read code P22FF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22FF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (FF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22FF mean?
SCR catalyst inlet temperature too low. The control unit detected that the exhaust gas at the SCR catalyst inlet is too cold for the AdBlue system to work properly. Below a certain temperature, dosing cannot take place or is not effective. It can be a result of how the car is used, but also of a fault.
Can I keep driving with code P22FF active?
With caution: limp mode possible, have it checked soon
Common causes — P22FF
Short, low-load trips that never heat the exhaust Faulty exhaust temperature sensor Exhaust leak before the SCR Engine thermal management problems, such as thermostat or EGR system Damaged exhaust insulation or components Very cold weather
How do you fix code P22FF?
First try a longer trip at steady speed and see whether the code returns. If it does, have the temperature sensors and exhaust sealing checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22FE — NOx sensor sensing element, bank 1 sensor 2
- Next code: P2300 — Ignition coil A primary control circuit low
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3