P22FE — NOx sensor sensing element, bank 1 sensor 2
| Meaning | The control unit detected a problem with the sensing element of the NOx sensor downstream of the SCR (sensor 2, bank 1). The part that measures nitrogen oxides is giving inconsistent values. Until it is checked, there is no way to know whether the SCR really works well. |
| Family | Powertrain (P) |
Typical symptoms
Fault message for the AdBlue system
Higher than normal emissions
Possible power limitation
Irregular AdBlue dosing
Common causes
Contamination by soot, oil or water
Impact or thermal shock on the sensor
Damaged wiring or connector
Faulty sensor electronic module
What to do
How to read code P22FE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22FE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (FE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22FE mean?
NOx sensor sensing element, bank 1 sensor 2. The control unit detected a problem with the sensing element of the NOx sensor downstream of the SCR (sensor 2, bank 1). The part that measures nitrogen oxides is giving inconsistent values. Until it is checked, there is no way to know whether the SCR really works well.
Can I keep driving with code P22FE active?
With caution: limp mode possible, have it checked soon
Common causes — P22FE
Damaged or exhausted sensing element Contamination by soot, oil or water Impact or thermal shock on the sensor Damaged wiring or connector Faulty sensor electronic module
How do you fix code P22FE?
Have the sensor, module and wiring checked, starting with the connector. If the fault remains, some vehicles apply limitations, so it's best to act soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22FD — NOx sensor slow response high to low, bank 1 senso...
- Next code: P22FF — SCR catalyst inlet temperature too low
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3