Skip to content
Fault code dictionary (DTC)

P2350 — Cylinder 9 pressure variation too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe computer noticed that pressure in cylinder 9 changes from one cycle to the next more than it should. It may point to unstable combustion in that cylinder or to a noisy sensor signal. The exact meaning depends on the manufacturer and I cannot specify it without knowing the make.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough or jerky engine
Irregular idle
Loss of power
Vibrations more noticeable than usual

Common causes

Occasional misfires in cylinder 9
Spark plug, coil or injector of cylinder 9 not working properly
Unstable mixture from too much or too little air
Noisy or faulty pressure sensor
Wiring with a poor contact
Mechanical problem in the cylinder

What to do

Have the spark plug, coil and injector of cylinder 9 checked, then the sensor. If the engine jerks hard at times or the warning light flashes, reduce use of the car, because misfires can damage the catalytic converter.

How to read code P2350

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2350 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (50) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2350 mean?

Cylinder 9 pressure variation too high. The computer noticed that pressure in cylinder 9 changes from one cycle to the next more than it should. It may point to unstable combustion in that cylinder or to a noisy sensor signal. The exact meaning depends on the manufacturer and I cannot specify it without knowing the make.

Can I keep driving with code P2350 active?

With caution: limp mode possible, have it checked soon

Common causes — P2350

Occasional misfires in cylinder 9 Spark plug, coil or injector of cylinder 9 not working properly Unstable mixture from too much or too little air Noisy or faulty pressure sensor Wiring with a poor contact Mechanical problem in the cylinder

How do you fix code P2350?

Have the spark plug, coil and injector of cylinder 9 checked, then the sensor. If the engine jerks hard at times or the warning light flashes, reduce use of the car, because misfires can damage the catalytic converter.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes