P2352 — Cylinder 10 pressure sensor circuit fault
| Meaning | The engine computer found a general problem in the electrical circuit of the sensor that measures pressure inside cylinder 10. These sensors are fitted only to some engines and the exact fault meaning depends on the manufacturer, so I cannot say more without knowing the make. In practice the computer no longer trusts the signal coming from that cylinder. |
| Family | Powertrain (P) |
Typical symptoms
Slightly irregular engine running
Loss of power in some conditions
Unstable idle
No obvious symptoms in milder cases
Common causes
Damaged, chafed or broken wiring
Faulty cylinder 10 pressure sensor
Power supply or ground problem at the sensor
Engine control unit, in rare cases
What to do
How to read code P2352
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2352 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (52) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2352 mean?
Cylinder 10 pressure sensor circuit fault. The engine computer found a general problem in the electrical circuit of the sensor that measures pressure inside cylinder 10. These sensors are fitted only to some engines and the exact fault meaning depends on the manufacturer, so I cannot say more without knowing the make. In practice the computer no longer trusts the signal coming from that cylinder.
Can I keep driving with code P2352 active?
With caution: limp mode possible, have it checked soon
Common causes — P2352
Sensor connector corroded, loose or dirty Damaged, chafed or broken wiring Faulty cylinder 10 pressure sensor Power supply or ground problem at the sensor Engine control unit, in rare cases
How do you fix code P2352?
First check the connector and wiring of the cylinder 10 sensor, looking for moisture, corrosion or damaged wires. You can drive carefully for a short time, but have the car checked soon, because the computer may limit how it manages that cylinder.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2351 — Cylinder 9 combustion performance fault
- Next code: P2353 — Cylinder 10 pressure sensor signal out of range
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit