P2355 — Cylinder 10 pressure sensor circuit high
| Meaning | The engine computer reads a higher than normal voltage from the cylinder 10 pressure sensor. This usually points to an electrical problem: a wire touching the supply, an open circuit or a faulty sensor. The details depend on the manufacturer and I cannot specify them without knowing the make. |
| Family | Powertrain (P) |
Typical symptoms
Irregular idle
Occasional power drops
Less smooth engine running
No obvious symptoms in mild cases
Common causes
Open circuit from a broken wire or connector
Faulty cylinder 10 pressure sensor
Sensor ground missing or in poor condition
Engine control unit, in rare cases
What to do
How to read code P2355
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2355 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (55) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2355 mean?
Cylinder 10 pressure sensor circuit high. The engine computer reads a higher than normal voltage from the cylinder 10 pressure sensor. This usually points to an electrical problem: a wire touching the supply, an open circuit or a faulty sensor. The details depend on the manufacturer and I cannot specify them without knowing the make.
Can I keep driving with code P2355 active?
With caution: limp mode possible, have it checked soon
Common causes — P2355
Signal wire shorted to the supply voltage Open circuit from a broken wire or connector Faulty cylinder 10 pressure sensor Sensor ground missing or in poor condition Engine control unit, in rare cases
How do you fix code P2355?
Have the ground, supply and wiring of the cylinder 10 sensor checked first. It is not normally an immediate emergency, but do not put the check off for too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2354 — Cylinder 10 pressure sensor circuit low
- Next code: P2356 — Cylinder 10 pressure sensor intermittent signal
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit