P2356 — Cylinder 10 pressure sensor intermittent signal
| Meaning | The signal from the cylinder 10 pressure sensor comes and goes: the computer sees it jump or disappear irregularly. This is typical of a poor electrical contact that shows up with vibration, heat or moisture. The exact meaning depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Idle that comes and goes
Small jerks or occasional power drops
Problem that appears only when hot or on rough roads
No obvious symptoms between episodes
Common causes
Chafed wiring that touches only at times
Cylinder 10 pressure sensor starting to fail
Moisture in the connector
Unstable ground or supply
Engine control unit, in rare cases
What to do
How to read code P2356
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2356 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (56) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2356 mean?
Cylinder 10 pressure sensor intermittent signal. The signal from the cylinder 10 pressure sensor comes and goes: the computer sees it jump or disappear irregularly. This is typical of a poor electrical contact that shows up with vibration, heat or moisture. The exact meaning depends on the manufacturer.
Can I keep driving with code P2356 active?
With caution: limp mode possible, have it checked soon
Common causes — P2356
Sensor connector with corroded or loose contacts Chafed wiring that touches only at times Cylinder 10 pressure sensor starting to fail Moisture in the connector Unstable ground or supply Engine control unit, in rare cases
How do you fix code P2356?
Check the connector and wiring by gently moving them with the engine off, looking for corrosion or damaged wires. Intermittent faults are the hardest to find: note when they appear and tell whoever inspects the car.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2355 — Cylinder 10 pressure sensor circuit high
- Next code: P2357 — Cylinder 10 pressure too low
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit