P2358 — Cylinder 10 pressure too high
| Meaning | The sensor shows that pressure in cylinder 10 exceeds what the computer expects. It may be combustion that is too violent or too early, or a sensor reading wrongly. The exact detection criterion depends on the manufacturer and I cannot be more specific without knowing the make. |
| Family | Powertrain (P) |
Typical symptoms
Metallic noise or pinging under load
Rough or irregular engine
Loss of power
Overheating in heavy use
Common causes
Carbon deposits in the combustion chamber
Unsuitable fuel or lean mixture
Spark plug or injector of cylinder 10 not working properly
Cylinder 10 pressure sensor out of calibration
Ignition timing out of control
What to do
How to read code P2358
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2358 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (58) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2358 mean?
Cylinder 10 pressure too high. The sensor shows that pressure in cylinder 10 exceeds what the computer expects. It may be combustion that is too violent or too early, or a sensor reading wrongly. The exact detection criterion depends on the manufacturer and I cannot be more specific without knowing the make.
Can I keep driving with code P2358 active?
With caution: limp mode possible, have it checked soon
Common causes — P2358
Knock or pre-ignition in cylinder 10 Carbon deposits in the combustion chamber Unsuitable fuel or lean mixture Spark plug or injector of cylinder 10 not working properly Cylinder 10 pressure sensor out of calibration Ignition timing out of control
How do you fix code P2358?
Avoid heavy loads and hard acceleration, because excessive pressure can damage pistons and gaskets. Have the spark plug, injector, fuel used and cylinder 10 sensor checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2357 — Cylinder 10 pressure too low
- Next code: P2359 — Cylinder 10 pressure variation too low
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit