P2359 — Cylinder 10 pressure variation too low
| Meaning | The computer noticed that pressure in cylinder 10 changes from one cycle to the next less than it should. This can mean a sensor that is not responding well, or combustion that is more uniform than expected. The exact meaning is set by the manufacturer and I have no reliable basis to state it without knowing the make. |
| Family | Powertrain (P) |
Typical symptoms
Not very smooth running
Slight loss of power
Uneven idle
No obvious symptoms in mild cases
Common causes
Wiring or connector giving a weakened signal
Abnormal combustion in cylinder 10
Spark plug or injector not working properly
Engine control unit, in rare cases
What to do
How to read code P2359
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2359 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (59) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2359 mean?
Cylinder 10 pressure variation too low. The computer noticed that pressure in cylinder 10 changes from one cycle to the next less than it should. This can mean a sensor that is not responding well, or combustion that is more uniform than expected. The exact meaning is set by the manufacturer and I have no reliable basis to state it without knowing the make.
Can I keep driving with code P2359 active?
With caution: limp mode possible, have it checked soon
Common causes — P2359
Sluggish or fouled cylinder 10 pressure sensor Wiring or connector giving a weakened signal Abnormal combustion in cylinder 10 Spark plug or injector not working properly Engine control unit, in rare cases
How do you fix code P2359?
Start by checking the sensor and its wiring, then compare cylinder 10 data with the others. It is not normally urgent, but have it checked within a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2358 — Cylinder 10 pressure too high
- Next code: P235A — Cylinder 10: combustion pressure variation too hig...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit