Skip to content
Fault code dictionary (DTC)

P2360 — Cylinder 11: pressure sensor signal intermittent

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit sees the cylinder 11 pressure sensor signal appearing and disappearing or varying erratically. It is usually a contact that breaks now and then because of vibration or heat. The code is standard and applies to very rare engines with 11 or more cylinders.
FamilyPowertrain (P)

Typical symptoms

Check engine light coming on and going off
Engine irregularity only at times
Occasional slight loss of power
Problem showing up with vibration or after warm-up
Variable fuel consumption
No obvious symptoms between episodes

Common causes

Loose sensor connector or corroded contacts
Wire partly broken inside its insulation
Wiring rubbing against engine parts
Cylinder pressure sensor starting to fail
Intermittent ground or supply problem
Faulty internal contact in the control unit, which is rare

What to do

Have the wiring and connector gently moved with the engine running to see whether the signal drops out. An intermittent fault tends to get worse, so it is best to have it checked before it becomes permanent.

How to read code P2360

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2360 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (60) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2360 mean?

Cylinder 11: pressure sensor signal intermittent. The control unit sees the cylinder 11 pressure sensor signal appearing and disappearing or varying erratically. It is usually a contact that breaks now and then because of vibration or heat. The code is standard and applies to very rare engines with 11 or more cylinders.

Can I keep driving with code P2360 active?

With caution: limp mode possible, have it checked soon

Common causes — P2360

Loose sensor connector or corroded contacts Wire partly broken inside its insulation Wiring rubbing against engine parts Cylinder pressure sensor starting to fail Intermittent ground or supply problem Faulty internal contact in the control unit, which is rare

How do you fix code P2360?

Have the wiring and connector gently moved with the engine running to see whether the signal drops out. An intermittent fault tends to get worse, so it is best to have it checked before it becomes permanent.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes