Skip to content
Fault code dictionary (DTC)

P235F — Cylinder 11: pressure sensor signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit reads a voltage on the cylinder 11 pressure sensor circuit that is higher than the expected maximum. It usually points to a short to supply voltage, a missing ground, or a faulty sensor. The code is standard and applies to very rare engines with 11 or more cylinders.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Occasionally uneven running
Slight drop in performance
Less precise combustion control
Slightly abnormal fuel consumption
Often no obvious symptoms

Common causes

Sensor wire shorted to supply voltage
Interrupted or corroded sensor ground
Faulty cylinder pressure sensor
Damaged connector or moisture in it
Internal control unit fault, which is rare

What to do

Have the wiring, connector and sensor ground checked, looking for damaged insulation or corroded contacts. You can drive carefully for a short time, but it is best to have it checked soon.

How to read code P235F

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P235F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (5F) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P235F mean?

Cylinder 11: pressure sensor signal too high. The control unit reads a voltage on the cylinder 11 pressure sensor circuit that is higher than the expected maximum. It usually points to a short to supply voltage, a missing ground, or a faulty sensor. The code is standard and applies to very rare engines with 11 or more cylinders.

Can I keep driving with code P235F active?

With caution: limp mode possible, have it checked soon

Common causes — P235F

Sensor wire shorted to supply voltage Interrupted or corroded sensor ground Faulty cylinder pressure sensor Damaged connector or moisture in it Internal control unit fault, which is rare

How do you fix code P235F?

Have the wiring, connector and sensor ground checked, looking for damaged insulation or corroded contacts. You can drive carefully for a short time, but it is best to have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes