P2374 — Turbo inlet pressure sensor B circuit fault
| Meaning | The control unit found a problem in the circuit of sensor B, which measures pressure at the inlet of the turbocharger or supercharger. The code is generic and does not say whether the fault is electrical or in the sensor. Without this data, air management can be inaccurate. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Slow response on acceleration
Exhaust smoke
Higher fuel use
Common causes
Damaged wiring
Dirty or faulty sensor
Leaks in the air pipes
Heavily clogged air filter
What to do
How to read code P2374
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2374 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (74) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2374 mean?
Turbo inlet pressure sensor B circuit fault. The control unit found a problem in the circuit of sensor B, which measures pressure at the inlet of the turbocharger or supercharger. The code is generic and does not say whether the fault is electrical or in the sensor. Without this data, air management can be inaccurate.
Can I keep driving with code P2374 active?
With caution: limp mode possible, have it checked soon
Common causes — P2374
Corroded or loose sensor connector Damaged wiring Dirty or faulty sensor Leaks in the air pipes Heavily clogged air filter
How do you fix code P2374?
Check the sensor connector and wiring and the condition of the air filter. You can drive carefully, but the engine may go into protection mode, so don't wait too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2373 — Fuel volume regulator B: control circuit high
- Next code: P2375 — Turbo inlet pressure sensor B out of range
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit