P2373 — Fuel volume regulator B: control circuit high
| Meaning | The control unit reads a higher voltage than expected on the control circuit of regulator B. It can point to a short to supply voltage, faulty wiring or an internal fault. The regulator controls how much fuel goes to the high-pressure pump. |
| Family | Powertrain (P) |
Typical symptoms
Engine won't start or starts poorly
Loss of power
Abnormal fuel pressure
Uneven running
Common causes
Faulty regulator
Damaged connector
Driver fault in the control unit
Wiring damaged by heat
What to do
How to read code P2373
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2373 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (73) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2373 mean?
Fuel volume regulator B: control circuit high. The control unit reads a higher voltage than expected on the control circuit of regulator B. It can point to a short to supply voltage, faulty wiring or an internal fault. The regulator controls how much fuel goes to the high-pressure pump.
Can I keep driving with code P2373 active?
With caution: limp mode possible, have it checked soon
Common causes — P2373
Wire shorted to supply voltage Faulty regulator Damaged connector Driver fault in the control unit Wiring damaged by heat
How do you fix code P2373?
Check the wiring and connector and verify the voltage on the circuit. If the car is hard to drive, stop and have it checked rather than pushing on.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2372 — Fuel volume regulator B: control circuit low
- Next code: P2374 — Turbo inlet pressure sensor B circuit fault
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit