P2376 — Turbo inlet pressure sensor B circuit low
| Meaning | The control unit reads a lower than normal voltage from sensor B at the turbo inlet. It usually points to a wire shorted to ground, a break or a faulty sensor. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Engine in protection mode
Slow throttle response
Abnormal smoke
Common causes
Faulty sensor
Damaged connector
Missing sensor supply
Broken wiring
What to do
How to read code P2376
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2376 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (76) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2376 mean?
Turbo inlet pressure sensor B circuit low. The control unit reads a lower than normal voltage from sensor B at the turbo inlet. It usually points to a wire shorted to ground, a break or a faulty sensor.
Can I keep driving with code P2376 active?
With caution: limp mode possible, have it checked soon
Common causes — P2376
Wire shorted to ground Faulty sensor Damaged connector Missing sensor supply Broken wiring
How do you fix code P2376?
Check the wiring and connector and measure the sensor's supply and signal. If power drops a lot, avoid long trips until it is fixed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2375 — Turbo inlet pressure sensor B out of range
- Next code: P2377 — Turbo inlet pressure sensor B circuit high
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit