P2377 — Turbo inlet pressure sensor B circuit high
| Meaning | The control unit reads a higher than normal voltage from sensor B at the turbo inlet. It can come from a short to supply voltage, a broken ground wire or the sensor itself. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Engine in protection mode
Uneven running
Abnormal smoke
Common causes
Broken sensor ground
Faulty sensor
Damaged connector
Control unit fault, rare
What to do
How to read code P2377
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2377 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (77) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2377 mean?
Turbo inlet pressure sensor B circuit high. The control unit reads a higher than normal voltage from sensor B at the turbo inlet. It can come from a short to supply voltage, a broken ground wire or the sensor itself.
Can I keep driving with code P2377 active?
With caution: limp mode possible, have it checked soon
Common causes — P2377
Short to supply voltage Broken sensor ground Faulty sensor Damaged connector Control unit fault, rare
How do you fix code P2377?
Check the connector, ground and supply of the sensor. Don't replace the sensor before checking the wires.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2376 — Turbo inlet pressure sensor B circuit low
- Next code: P2378 — Turbo inlet pressure sensor B intermittent signal
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit