P2379 — O2 sensor bank 2 sensor 2 out of range on decel
| Meaning | The downstream sensor after the bank 2 catalytic converter gave values outside the expected range while you were off the throttle. The control unit uses this phase to check the sensor. The fault may be in the sensor or in exhaust conditions. |
| Family | Powertrain (P) |
Typical symptoms
Usually no obvious change in driving
Sometimes slightly higher fuel use
Possible emissions test failure
Unusual smell from the exhaust
Common causes
Damaged wiring or connector
Exhaust leak near the sensor
Poor bank 2 catalytic converter
Wrong mixture from the engine
What to do
How to read code P2379
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2379 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (79) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2379 mean?
O2 sensor bank 2 sensor 2 out of range on decel. The downstream sensor after the bank 2 catalytic converter gave values outside the expected range while you were off the throttle. The control unit uses this phase to check the sensor. The fault may be in the sensor or in exhaust conditions.
Can I keep driving with code P2379 active?
With caution: limp mode possible, have it checked soon
Common causes — P2379
Aged bank 2 downstream sensor Damaged wiring or connector Exhaust leak near the sensor Poor bank 2 catalytic converter Wrong mixture from the engine
How do you fix code P2379?
Check the sensor wiring and look for exhaust leaks before replacing the sensor. It is usually not urgent, but don't ignore it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2378 — Turbo inlet pressure sensor B intermittent signal
- Next code: P237A — O2 sensor bank 1 sensor 2 exhaust sample error
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit