P2378 — Turbo inlet pressure sensor B intermittent signal
| Meaning | The signal from sensor B at the turbo inlet jumps or drops out intermittently. This is typical of a weak contact that shows up with vibration or heat, rather than a stable fault. |
| Family | Powertrain (P) |
Typical symptoms
Power loss at times
Uneven response
Intermittent protection mode
Hesitation on acceleration
Common causes
Partly broken wire
Sensor with an internal fault
Chafing wiring
Unstable ground or supply
What to do
How to read code P2378
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2378 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (78) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2378 mean?
Turbo inlet pressure sensor B intermittent signal. The signal from sensor B at the turbo inlet jumps or drops out intermittently. This is typical of a weak contact that shows up with vibration or heat, rather than a stable fault.
Can I keep driving with code P2378 active?
With caution: limp mode possible, have it checked soon
Common causes — P2378
Loose or corroded connector Partly broken wire Sensor with an internal fault Chafing wiring Unstable ground or supply
How do you fix code P2378?
Carefully wiggle the connector and wiring with the engine running and watch whether the reading changes. Intermittent faults are hard to trace, so fix it before it becomes permanent.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2377 — Turbo inlet pressure sensor B circuit high
- Next code: P2379 — O2 sensor bank 2 sensor 2 out of range on decel
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit