P2380 — EGR sensor D circuit fault
| Meaning | The control unit detected a problem in the circuit of sensor D in the EGR system, which recirculates part of the exhaust gas. The code is generic: it does not say what sensor D measures, as that depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Higher emissions
Exhaust smoke
Common causes
Damaged wiring
Faulty or soot-fouled sensor
Clogged EGR valve
Control unit fault, rare
What to do
How to read code P2380
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2380 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (80) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2380 mean?
EGR sensor D circuit fault. The control unit detected a problem in the circuit of sensor D in the EGR system, which recirculates part of the exhaust gas. The code is generic: it does not say what sensor D measures, as that depends on the manufacturer.
Can I keep driving with code P2380 active?
With caution: limp mode possible, have it checked soon
Common causes — P2380
Corroded or loose sensor connector Damaged wiring Faulty or soot-fouled sensor Clogged EGR valve Control unit fault, rare
How do you fix code P2380?
Check the sensor connector and wiring and the condition of the EGR valve. You can drive carefully, but act soon as emissions get worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P237F — Exhaust heat exchanger bypass valve A: performance
- Next code: P2381 — EGR sensor D circuit high
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit