P2381 — EGR sensor D circuit high
| Meaning | The control unit reads a higher than expected voltage from sensor D in the EGR system. It can come from a short to supply voltage, a broken ground or the sensor itself. What sensor D measures depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Higher emissions
Abnormal smoke
Common causes
Broken sensor ground
Faulty or fouled sensor
Damaged connector
Control unit fault, rare
What to do
How to read code P2381
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2381 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (81) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2381 mean?
EGR sensor D circuit high. The control unit reads a higher than expected voltage from sensor D in the EGR system. It can come from a short to supply voltage, a broken ground or the sensor itself. What sensor D measures depends on the manufacturer.
Can I keep driving with code P2381 active?
With caution: limp mode possible, have it checked soon
Common causes — P2381
Short to supply voltage Broken sensor ground Faulty or fouled sensor Damaged connector Control unit fault, rare
How do you fix code P2381?
Check the connector, ground and supply of the sensor. Also inspect the EGR valve before replacing parts.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2380 — EGR sensor D circuit fault
- Next code: P2382 — EGR sensor D circuit: signal too low
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit