P2393 — Diesel intake air flow B control: circuit high
| Meaning | The control unit has detected too high a voltage on the control circuit of the second intake air regulating device on diesel engines ("B"). Usually the control wire is touching the supply voltage, or the circuit or actuator is damaged. Which component it is depends on the manufacturer, and for some brands I have no reliable information. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Unstable idle
Abnormal exhaust smoke
Limp mode on some cars
Common causes
Faulty actuator
Damaged connector or contacts shorting together
Damaged wiring
Control unit driver stage faulty (rare)
What to do
How to read code P2393
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2393 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (93) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2393 mean?
Diesel intake air flow B control: circuit high. The control unit has detected too high a voltage on the control circuit of the second intake air regulating device on diesel engines ("B"). Usually the control wire is touching the supply voltage, or the circuit or actuator is damaged. Which component it is depends on the manufacturer, and for some brands I have no reliable information.
Can I keep driving with code P2393 active?
With caution: limp mode possible, have it checked soon
Common causes — P2393
Control wire shorted to the supply voltage Faulty actuator Damaged connector or contacts shorting together Damaged wiring Control unit driver stage faulty (rare)
How do you fix code P2393?
Check the actuator wiring and connector and have a scan tool verify the command and response. Don't delay too long: a short to supply voltage can damage other components too.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2392 — Diesel intake air flow B control: circuit low
- Next code: P2394 — Diesel intake air flow B control: stuck open
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit