P2392 — Diesel intake air flow B control: circuit low
| Meaning | The control unit has detected too low a voltage on the control circuit of the second intake air regulating device on diesel engines ("B"). Usually the control wire is shorted to ground or the actuator has an internal short. Which component it is depends on the manufacturer, and for some brands I have no reliable information. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Rough idle
Abnormal exhaust smoke
Limp mode on some cars
Common causes
Actuator with an internal short
Corroded or wet connector
Pinched or chafed wiring
Control unit driver stage damaged (rare)
What to do
How to read code P2392
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2392 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (92) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2392 mean?
Diesel intake air flow B control: circuit low. The control unit has detected too low a voltage on the control circuit of the second intake air regulating device on diesel engines ("B"). Usually the control wire is shorted to ground or the actuator has an internal short. Which component it is depends on the manufacturer, and for some brands I have no reliable information.
Can I keep driving with code P2392 active?
With caution: limp mode possible, have it checked soon
Common causes — P2392
Control wire shorted to ground or with damaged insulation Actuator with an internal short Corroded or wet connector Pinched or chafed wiring Control unit driver stage damaged (rare)
How do you fix code P2392?
Inspect the actuator wiring and connector for chafed or damp spots and have it checked with a scan tool. Avoid pushing on if power drops: have the car checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2391 — Diesel intake air flow B control: performance prob...
- Next code: P2393 — Diesel intake air flow B control: circuit high
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit