P2398 — Diesel intake air flow B position sensor circuit low
| Meaning | The engine computer sees a voltage that is too low on the circuit of the second intake air valve position sensor, outside normal limits. In practice the signal looks shorted to ground or cut off. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Limp mode
Unstable idle
Abnormal exhaust smoke
Common causes
Damaged or wet connector
Internal sensor failure
Sensor power supply interrupted
Engine computer, which is rare
What to do
How to read code P2398
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2398 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (98) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2398 mean?
Diesel intake air flow B position sensor circuit low. The engine computer sees a voltage that is too low on the circuit of the second intake air valve position sensor, outside normal limits. In practice the signal looks shorted to ground or cut off.
Can I keep driving with code P2398 active?
With caution: limp mode possible, have it checked soon
Common causes — P2398
Signal wire touching ground Damaged or wet connector Internal sensor failure Sensor power supply interrupted Engine computer, which is rare
How do you fix code P2398?
Check the wiring between the sensor and the computer, especially where wires run near hot or metal parts. Have it looked at soon, especially if the car is in limp mode.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2397 — Diesel intake air flow B position sensor range/per...
- Next code: P2399 — Diesel intake air flow B position sensor circuit h...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit