Skip to content
Fault code dictionary (DTC)

P23AA — Turbo/supercharger bypass valve A stuck

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module detected that bypass valve A on the turbocharger or supercharger is not moving as commanded and treats it as stuck. This valve relieves boost pressure when it is not needed. If it stays put, the boost pressure can end up too high or too low.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power or weak pulling
Hissing or air-release noises when you lift off the throttle
Possible limp mode with limited power
Uneven throttle response

Common causes

Valve stuck with dirt, oil or deposits
Faulty electric or vacuum actuator
Cracked or disconnected vacuum hose
Damaged wiring or connector on the actuator
Broken internal diaphragm in the valve
Valve mechanically seized or broken

What to do

First check the hoses and connections going to the valve, then see if it moves freely. If power is limited you can drive carefully to a workshop, but avoid heavy load: uncontrolled boost can damage the turbo.

How to read code P23AA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P23AA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (AA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P23AA mean?

Turbo/supercharger bypass valve A stuck. The control module detected that bypass valve A on the turbocharger or supercharger is not moving as commanded and treats it as stuck. This valve relieves boost pressure when it is not needed. If it stays put, the boost pressure can end up too high or too low.

Can I keep driving with code P23AA active?

With caution: limp mode possible, have it checked soon

Common causes — P23AA

Valve stuck with dirt, oil or deposits Faulty electric or vacuum actuator Cracked or disconnected vacuum hose Damaged wiring or connector on the actuator Broken internal diaphragm in the valve Valve mechanically seized or broken

How do you fix code P23AA?

First check the hoses and connections going to the valve, then see if it moves freely. If power is limited you can drive carefully to a workshop, but avoid heavy load: uncontrolled boost can damage the turbo.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes