P23AB — NOx sensor bank 1 sensor 3: internal processor fault
| Meaning | The control module detected a problem in the internal electronics of the NOx sensor, the part that measures nitrogen oxides in the exhaust. Bank 1 is the side of the engine with cylinder 1, and where sensor 3 sits depends on the manufacturer. This sensor has its own small internal control unit, and the code says it is not working correctly. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the exhaust treatment or AdBlue system, if fitted
Possible power limitation on some vehicles
Higher than normal emissions
Failed emissions inspection
Common causes
Connector with moisture or corrosion
Damaged or shorted wiring
Unstable supply voltage (battery or fuses)
Engine control module fault, which is rare
What to do
How to read code P23AB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23AB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (AB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23AB mean?
NOx sensor bank 1 sensor 3: internal processor fault. The control module detected a problem in the internal electronics of the NOx sensor, the part that measures nitrogen oxides in the exhaust. Bank 1 is the side of the engine with cylinder 1, and where sensor 3 sits depends on the manufacturer. This sensor has its own small internal control unit, and the code says it is not working correctly.
Can I keep driving with code P23AB active?
With caution: limp mode possible, have it checked soon
Common causes — P23AB
Faulty NOx sensor (internal electronics) Connector with moisture or corrosion Damaged or shorted wiring Unstable supply voltage (battery or fuses) Engine control module fault, which is rare
How do you fix code P23AB?
First check the connector, wiring and battery, then have the sensor data read. Don't ignore it: on many diesel vehicles the system can limit power or prevent restarting if the fault remains.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23AA — Turbo/supercharger bypass valve A stuck
- Next code: P23AC — NOx sensor bank 1 sensor 3: circuit fault
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit