Skip to content
Fault code dictionary (DTC)

P23AC — NOx sensor bank 1 sensor 3: circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module detected a general electrical fault in the NOx sensor circuit, which measures nitrogen oxides in the exhaust. Bank 1 is the side with cylinder 1, and the position of sensor 3 varies by manufacturer. The signal or connection is outside the expected values.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection

Common causes

Corroded or wet sensor connector
Broken, pinched or burnt wiring
Faulty NOx sensor
Blown fuse or supply problem for the sensor
Sensor control unit or engine module failure, which is rare

What to do

Look first at the connector and wiring, especially near hot exhaust parts. Then have the sensor supply and signal checked. Don't wait too long, because the system can limit power.

How to read code P23AC

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P23AC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (AC) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P23AC mean?

NOx sensor bank 1 sensor 3: circuit fault. The control module detected a general electrical fault in the NOx sensor circuit, which measures nitrogen oxides in the exhaust. Bank 1 is the side with cylinder 1, and the position of sensor 3 varies by manufacturer. The signal or connection is outside the expected values.

Can I keep driving with code P23AC active?

With caution: limp mode possible, have it checked soon

Common causes — P23AC

Corroded or wet sensor connector Broken, pinched or burnt wiring Faulty NOx sensor Blown fuse or supply problem for the sensor Sensor control unit or engine module failure, which is rare

How do you fix code P23AC?

Look first at the connector and wiring, especially near hot exhaust parts. Then have the sensor supply and signal checked. Don't wait too long, because the system can limit power.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes