P23AE — NOx sensor bank 1 sensor 3: circuit low
| Meaning | The control module reads a voltage or signal on the NOx sensor circuit that is lower than the expected minimum. It could be a wire shorted to ground, a broken contact or a faulty sensor. The position of sensor 3 changes by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection
Common causes
Corroded or wet connector
Faulty NOx sensor
Broken wiring or weak contact
Insufficient sensor supply
What to do
How to read code P23AE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23AE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (AE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23AE mean?
NOx sensor bank 1 sensor 3: circuit low. The control module reads a voltage or signal on the NOx sensor circuit that is lower than the expected minimum. It could be a wire shorted to ground, a broken contact or a faulty sensor. The position of sensor 3 changes by manufacturer.
Can I keep driving with code P23AE active?
With caution: limp mode possible, have it checked soon
Common causes — P23AE
Signal wire shorted to ground from worn insulation Corroded or wet connector Faulty NOx sensor Broken wiring or weak contact Insufficient sensor supply
How do you fix code P23AE?
First check wiring and connector, particularly where the wires run near the exhaust. Then have the sensor voltage and signal measured. Don't ignore the code for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23AD — NOx sensor bank 1 sensor 3: signal out of range/pe...
- Next code: P23AF — NOx sensor bank 1 sensor 3: circuit high
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit