P23AF — NOx sensor bank 1 sensor 3: circuit high
| Meaning | The control module reads a voltage or signal on the NOx sensor circuit that is higher than the expected maximum. It can come from a short to a power wire, damaged wiring or the sensor itself. The position of sensor 3 varies by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection
Common causes
Damaged or wet connector
Faulty NOx sensor
Wiring pinched or burnt by heat
Control module fault, which is rare
What to do
How to read code P23AF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23AF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (AF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23AF mean?
NOx sensor bank 1 sensor 3: circuit high. The control module reads a voltage or signal on the NOx sensor circuit that is higher than the expected maximum. It can come from a short to a power wire, damaged wiring or the sensor itself. The position of sensor 3 varies by manufacturer.
Can I keep driving with code P23AF active?
With caution: limp mode possible, have it checked soon
Common causes — P23AF
Signal wire touching a power wire Damaged or wet connector Faulty NOx sensor Wiring pinched or burnt by heat Control module fault, which is rare
How do you fix code P23AF?
First check the connector and wiring, looking for wires touching or heat damage. Then have the signal checked with a tester. Don't leave it for long, because the system can reduce power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23AE — NOx sensor bank 1 sensor 3: circuit low
- Next code: P23B0 — NOx sensor bank 1 sensor 3: intermittent circuit
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit