P23B8 — NOx sensor bank 1 sensor 3: heater sense circuit low
| Meaning | The control module reads a lower than expected signal on the NOx sensor heater monitoring circuit. It usually points to a short to ground, a broken wire or an internal sensor fault. Where sensor 3 sits depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection
Common causes
Corroded or wet connector
Faulty NOx sensor
Broken wiring or weak contact
Sensor control unit failure
What to do
How to read code P23B8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23B8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (B8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23B8 mean?
NOx sensor bank 1 sensor 3: heater sense circuit low. The control module reads a lower than expected signal on the NOx sensor heater monitoring circuit. It usually points to a short to ground, a broken wire or an internal sensor fault. Where sensor 3 sits depends on the manufacturer.
Can I keep driving with code P23B8 active?
With caution: limp mode possible, have it checked soon
Common causes — P23B8
Sense wire shorted to ground Corroded or wet connector Faulty NOx sensor Broken wiring or weak contact Sensor control unit failure
How do you fix code P23B8?
First check wiring and connector, especially near the exhaust. Then have the circuit measured with a tester. Don't wait too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23B7 — NOx sensor bank 1 sensor 3: heater control range/p...
- Next code: P23B9 — NOx sensor bank 1 sensor 3: heater sense circuit h...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit