P23B7 — NOx sensor bank 1 sensor 3: heater control range/performance
| Meaning | The control module detected that the NOx sensor heater control circuit is not responding as expected. The command is not fully broken, but the heater does not bring the sensor up to temperature the way it should. Where sensor 3 sits varies by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection
Common causes
Abnormal resistance in the connector or wiring
Aged NOx sensor
Unstable heater supply
Sensor control unit failure, which is rare
What to do
How to read code P23B7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23B7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (B7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23B7 mean?
NOx sensor bank 1 sensor 3: heater control range/performance. The control module detected that the NOx sensor heater control circuit is not responding as expected. The command is not fully broken, but the heater does not bring the sensor up to temperature the way it should. Where sensor 3 sits varies by manufacturer.
Can I keep driving with code P23B7 active?
With caution: limp mode possible, have it checked soon
Common causes — P23B7
Degraded sensor heater Abnormal resistance in the connector or wiring Aged NOx sensor Unstable heater supply Sensor control unit failure, which is rare
How do you fix code P23B7?
First check the connector, wiring and voltage at the sensor. Then have the heater resistance measured and the data read. Don't ignore the code for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23B6 — NOx sensor bank 1 sensor 3: supply voltage circuit...
- Next code: P23B8 — NOx sensor bank 1 sensor 3: heater sense circuit l...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit