P23BB — NOx sensor bank 1 sensor 3: heater resistance fault
| Meaning | The control module measured an electrical resistance in the NOx sensor heater that is outside the expected values. A heater with resistance that is too high or too low does not bring the sensor to the right temperature. Where sensor 3 sits varies by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection
Common causes
NOx sensor at the end of its life
Connector or wiring with abnormal resistance
Corroded contacts in the heater circuit
Sensor control unit failure, which is rare
What to do
How to read code P23BB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23BB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (BB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23BB mean?
NOx sensor bank 1 sensor 3: heater resistance fault. The control module measured an electrical resistance in the NOx sensor heater that is outside the expected values. A heater with resistance that is too high or too low does not bring the sensor to the right temperature. Where sensor 3 sits varies by manufacturer.
Can I keep driving with code P23BB active?
With caution: limp mode possible, have it checked soon
Common causes — P23BB
Degraded heater inside the sensor NOx sensor at the end of its life Connector or wiring with abnormal resistance Corroded contacts in the heater circuit Sensor control unit failure, which is rare
How do you fix code P23BB?
First check the connector and wiring, then have the heater resistance measured. If the value is out of limits, the sensor usually needs replacing. Don't ignore the code for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23BA — NOx sensor bank 1 sensor 3: heater sense circuit i...
- Next code: P23BC — NOx sensor bank 1 sensor 3: calibration memory fau...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit