P23BC — NOx sensor bank 1 sensor 3: calibration memory fault
| Meaning | The NOx sensor control unit or the engine control module detected an error in the stored calibration data. This data is needed to interpret the sensor's measurements correctly. If it is corrupted or missing, readings can be wrong. Where sensor 3 sits depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection
Common causes
Sensor recently replaced without pairing or coding, if the manufacturer requires it
Power interruption while data was being written
Engine control module problem
Unstable supply voltage
What to do
How to read code P23BC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23BC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (BC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23BC mean?
NOx sensor bank 1 sensor 3: calibration memory fault. The NOx sensor control unit or the engine control module detected an error in the stored calibration data. This data is needed to interpret the sensor's measurements correctly. If it is corrupted or missing, readings can be wrong. Where sensor 3 sits depends on the manufacturer.
Can I keep driving with code P23BC active?
With caution: limp mode possible, have it checked soon
Common causes — P23BC
Faulty NOx sensor with damaged internal memory Sensor recently replaced without pairing or coding, if the manufacturer requires it Power interruption while data was being written Engine control module problem Unstable supply voltage
How do you fix code P23BC?
First check whether the sensor was replaced recently and whether it needs a coding procedure. Then a diagnosis with a tool suited to the brand is needed. Don't wait too long, because the system can limit power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23BB — NOx sensor bank 1 sensor 3: heater resistance faul...
- Next code: P23BD — NOx sensor 3 bank 1: signal biased or stuck high
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit