P23BE — NOx sensor 3 bank 1: signal biased or stuck low
| Meaning | The control unit found that NOx (nitrogen oxides) sensor number 3 reports a value that is too low, or stuck low, compared with what is expected. With such a reading the system cannot manage emissions properly. Which sensor is number 3 varies by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Emissions system warning message
Possible power reduction on some models
Exhaust additive consumption out of the normal range
Often no driving symptom
Common causes
Damaged wiring or connector
Insufficient supply or ground to the sensor
Moisture or contamination on the sensor
Fault in the NOx sensor control module
What to do
How to read code P23BE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23BE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (BE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23BE mean?
NOx sensor 3 bank 1: signal biased or stuck low. The control unit found that NOx (nitrogen oxides) sensor number 3 reports a value that is too low, or stuck low, compared with what is expected. With such a reading the system cannot manage emissions properly. Which sensor is number 3 varies by manufacturer.
Can I keep driving with code P23BE active?
With caution: limp mode possible, have it checked soon
Common causes — P23BE
Degraded or faulty NOx sensor Damaged wiring or connector Insufficient supply or ground to the sensor Moisture or contamination on the sensor Fault in the NOx sensor control module
How do you fix code P23BE?
Have the sensor supply, ground and connector checked, then read the live values. Do not delay too long, because the emissions system may restrict driving.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23BD — NOx sensor 3 bank 1: signal biased or stuck high
- Next code: P23BF — NOx sensor 3 bank 1: slow response from low to hig...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit