P23BF — NOx sensor 3 bank 1: slow response from low to high
| Meaning | When the amount of NOx (nitrogen oxides) in the exhaust rises, sensor number 3 follows the change too slowly. The control unit therefore no longer trusts its measurement. Which sensor is number 3 depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Emissions system warning message
Possible power limitation
Irregular exhaust additive consumption
No obvious symptom in many cases
Common causes
Dirty or contaminated sensing element
Exhaust leak near the sensor
Wiring or connector with poor contact
Fault in the sensor control module
What to do
How to read code P23BF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23BF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (BF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23BF mean?
NOx sensor 3 bank 1: slow response from low to high. When the amount of NOx (nitrogen oxides) in the exhaust rises, sensor number 3 follows the change too slowly. The control unit therefore no longer trusts its measurement. Which sensor is number 3 depends on the manufacturer.
Can I keep driving with code P23BF active?
With caution: limp mode possible, have it checked soon
Common causes — P23BF
Aged NOx sensor Dirty or contaminated sensing element Exhaust leak near the sensor Wiring or connector with poor contact Fault in the sensor control module
How do you fix code P23BF?
Have the sensor checked with live data, and check exhaust sealing and connectors. It is best to act early, before the system applies restrictions.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23BE — NOx sensor 3 bank 1: signal biased or stuck low
- Next code: P23C0 — NOx sensor 3 bank 1: slow response from high to lo...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit