Skip to content
Fault code dictionary (DTC)

P23C4 — Coolant bypass valve C: position sensor signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe electrical signal from the position sensor of coolant bypass valve C is lower than expected. This can point to a wire shorted to ground or a faulty sensor. Which valve is C depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Irregular engine temperature
Poor cabin heating
Cooling fan always or very active
Slow warm-up

Common causes

Sensor wire shorted to ground
Damaged or wet connector
Faulty position sensor
Faulty valve or actuator
Control unit fault

What to do

Have the valve wiring and connector checked and the sensor signal measured. Keep an eye on the engine temperature.

How to read code P23C4

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P23C4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (C4) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P23C4 mean?

Coolant bypass valve C: position sensor signal too low. The electrical signal from the position sensor of coolant bypass valve C is lower than expected. This can point to a wire shorted to ground or a faulty sensor. Which valve is C depends on the manufacturer.

Can I keep driving with code P23C4 active?

With caution: limp mode possible, have it checked soon

Common causes — P23C4

Sensor wire shorted to ground Damaged or wet connector Faulty position sensor Faulty valve or actuator Control unit fault

How do you fix code P23C4?

Have the valve wiring and connector checked and the sensor signal measured. Keep an eye on the engine temperature.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes