P23C5 — Coolant bypass valve C: position sensor signal too high
| Meaning | The electrical signal from the position sensor of coolant bypass valve C is higher than expected. This can point to a broken wire, poor contact or a faulty sensor. Which valve is C depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Irregular engine temperature
Poor cabin heating
Cooling fan very active
Abnormal warm-up
Common causes
Corroded or loose connector
Faulty position sensor
Faulty valve or actuator
Control unit fault
What to do
How to read code P23C5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23C5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (C5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23C5 mean?
Coolant bypass valve C: position sensor signal too high. The electrical signal from the position sensor of coolant bypass valve C is higher than expected. This can point to a broken wire, poor contact or a faulty sensor. Which valve is C depends on the manufacturer.
Can I keep driving with code P23C5 active?
With caution: limp mode possible, have it checked soon
Common causes — P23C5
Sensor wire broken or shorted to supply Corroded or loose connector Faulty position sensor Faulty valve or actuator Control unit fault
How do you fix code P23C5?
Have the valve wiring and connectors checked and the sensor signal verified. Monitor the engine temperature while driving.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23C4 — Coolant bypass valve C: position sensor signal too...
- Next code: P23C6 — Coolant bypass valve C: control circuit current or...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit