P2414 — O2 sensor exhaust sample error, bank 1 sensor 1
| Meaning | The engine computer believes the upstream oxygen sensor on bank 1 is not reading a correct exhaust gas sample. The precise meaning of this code varies between manufacturers, so I cannot give a more detailed reading with certainty. |
| Family | Powertrain (P) |
Typical symptoms
Abnormal fuel consumption
Rough idle
Possible emissions test failure
Common causes
Exhaust leak near the sensor
Damaged sensor wiring or connector
Sensor installed in the wrong position
Incorrect mixture caused by other faults
What to do
How to read code P2414
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2414 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (14) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2414 mean?
O2 sensor exhaust sample error, bank 1 sensor 1. The engine computer believes the upstream oxygen sensor on bank 1 is not reading a correct exhaust gas sample. The precise meaning of this code varies between manufacturers, so I cannot give a more detailed reading with certainty.
Can I keep driving with code P2414 active?
Yes, no known limitation
Common causes — P2414
Faulty or aged oxygen sensor Exhaust leak near the sensor Damaged sensor wiring or connector Sensor installed in the wrong position Incorrect mixture caused by other faults
How do you fix code P2414?
Have exhaust leaks and sensor wiring checked, then verify the sensor signal with a scan tool. It is not urgent, but do not put it off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2413 — EGR system performance problem
- Next code: P2415 — O2 sensor exhaust sample error, bank 2 sensor 1
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible