P241A — O2 sensor 1/1 and 1/2 oxygen concentration mismatch
| Meaning | The engine computer finds that the oxygen readings from the upstream and downstream sensors on bank 1 do not agree with each other. This wording is typical of some manufacturers, such as Nissan, and the detail may vary. |
| Family | Powertrain (P) |
Typical symptoms
Abnormal fuel consumption
Rough idle
Possible emissions test failure
Common causes
Aged upstream or downstream sensor
Poorly working catalytic converter
Damaged sensor wiring or connector
Wrong mixture from other faults
What to do
How to read code P241A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P241A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (1A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P241A mean?
O2 sensor 1/1 and 1/2 oxygen concentration mismatch. The engine computer finds that the oxygen readings from the upstream and downstream sensors on bank 1 do not agree with each other. This wording is typical of some manufacturers, such as Nissan, and the detail may vary.
Can I keep driving with code P241A active?
With caution: limp mode possible, have it checked soon
Common causes — P241A
Exhaust leak near the sensors Aged upstream or downstream sensor Poorly working catalytic converter Damaged sensor wiring or connector Wrong mixture from other faults
How do you fix code P241A?
First have exhaust leaks and wiring checked, then the signal of both sensors. It is not urgent, but do not delay too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2419 — EVAP switching valve control circuit low
- Next code: P241B — O2 sensor signals swapped, bank 2 (sensor 1 and 2)
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible