P2433 — Secondary air sensor circuit high, bank 1
| Meaning | The engine computer receives from the secondary air flow or pressure sensor on bank 1 a signal that is too high. This usually points to a broken wire, a short to supply voltage or a faulty sensor. The measurement is not reliable. |
| Family | Powertrain (P) |
Typical symptoms
Higher emissions when cold
Failed emissions check
Usually normal driving
Pressure or flow values too high seen with a scan tool
Common causes
Signal wire touching the supply wire
Faulty flow or pressure sensor
Corroded or bent terminals
Wiring damaged by heat
Engine computer fault (rare)
What to do
How to read code P2433
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2433 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (33) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2433 mean?
Secondary air sensor circuit high, bank 1. The engine computer receives from the secondary air flow or pressure sensor on bank 1 a signal that is too high. This usually points to a broken wire, a short to supply voltage or a faulty sensor. The measurement is not reliable.
Can I keep driving with code P2433 active?
With caution: limp mode possible, have it checked soon
Common causes — P2433
Sensor wire broken or connector unplugged Signal wire touching the supply wire Faulty flow or pressure sensor Corroded or bent terminals Wiring damaged by heat Engine computer fault (rare)
How do you fix code P2433?
First check that the connector is fully seated and the wires are not broken. Then have the circuit and sensor tested. You can drive, but the system does not work correctly while the fault is present.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2432 — Secondary air sensor circuit low, bank 1
- Next code: P2434 — Secondary air sensor intermittent, bank 1
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible