P2437 — Secondary air flow/pressure sensor bank 2: signal too low
| Meaning | The engine computer is getting a lower-than-normal voltage from the bank 2 secondary air sensor. This usually points to an electrical problem in the sensor circuit, such as a wire shorted to ground or a break, or to a faulty sensor. Bank 2 is the row of cylinders opposite cylinder 1. |
| Family | Powertrain (P) |
Typical symptoms
The computer switches the secondary air system off
Higher emissions after a cold start
Usually no difference in normal driving
Common causes
Broken sensor wire, or damaged insulation touching ground
Internal sensor failure
Missing sensor power supply
Faulty engine computer, which is very rare
What to do
How to read code P2437
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2437 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (37) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2437 mean?
Secondary air flow/pressure sensor bank 2: signal too low. The engine computer is getting a lower-than-normal voltage from the bank 2 secondary air sensor. This usually points to an electrical problem in the sensor circuit, such as a wire shorted to ground or a break, or to a faulty sensor. Bank 2 is the row of cylinders opposite cylinder 1.
Can I keep driving with code P2437 active?
With caution: limp mode possible, have it checked soon
Common causes — P2437
Oxidized or poorly seated sensor connector Broken sensor wire, or damaged insulation touching ground Internal sensor failure Missing sensor power supply Faulty engine computer, which is very rare
How do you fix code P2437?
Start with a visual check of the connector and wiring of the bank 2 sensor, looking for pinched, burnt or wet wires. You don't need to stop driving at once, but it shouldn't be ignored for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2436 — Secondary air flow/pressure sensor bank 2: signal...
- Next code: P2438 — Secondary air flow/pressure sensor bank 2: signal...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible