P2442 — Secondary air switching valve bank 2: stuck open
| Meaning | The engine computer has detected that the bank 2 secondary air valve stays open when it should be closed. Air can then enter the exhaust at the wrong time and skew the oxygen sensor data. Bank 2 is the row of cylinders opposite cylinder 1. |
| Family | Powertrain (P) |
Typical symptoms
Possible rough idle
Higher emissions
Noise from the air pump area
Other codes on the oxygen sensors
Common causes
Damaged valve diaphragm or spring
Faulty control solenoid
Control or vacuum hoses leaking
Condensation damaging the mechanism
What to do
How to read code P2442
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2442 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (42) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2442 mean?
Secondary air switching valve bank 2: stuck open. The engine computer has detected that the bank 2 secondary air valve stays open when it should be closed. Air can then enter the exhaust at the wrong time and skew the oxygen sensor data. Bank 2 is the row of cylinders opposite cylinder 1.
Can I keep driving with code P2442 active?
With caution: limp mode possible, have it checked soon
Common causes — P2442
Valve stuck open by dirt or rust Damaged valve diaphragm or spring Faulty control solenoid Control or vacuum hoses leaking Condensation damaging the mechanism
How do you fix code P2442?
Check the bank 2 valve and its control hoses to make sure it moves freely. It isn't an emergency, but it should be sorted soon as it falsifies the sensor data.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2441 — Secondary air switching valve bank 1: stuck closed
- Next code: P2443 — Secondary air switching valve bank 2: stuck closed
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible