P244D — Exhaust temperature too high for particulate filter regeneration (bank 1)
| Meaning | During particulate filter regeneration, the control unit detected an exhaust gas temperature above the expected maximum. Excessive temperatures can damage the filter, the catalyst and the sensors. The control unit usually stops or limits the regeneration to protect the system. |
| Family | Powertrain (P) |
Typical symptoms
Regeneration stopped or no longer starting
Loss of power or limp mode
Burning smell or a very hot exhaust after driving
Cooling fan running for a long time after the engine is off
Filter clogging because regenerations are being blocked
Common causes
Too much fuel sent to the exhaust during regeneration (injector or metering problem)
Filter heavily loaded with soot burning off violently
Damaged or partly melted catalyst or filter
Intake air or turbocharger problems that alter combustion
Cooling system or EGR faults
What to do
How to read code P244D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P244D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (4D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P244D mean?
Exhaust temperature too high for particulate filter regeneration (bank 1). During particulate filter regeneration, the control unit detected an exhaust gas temperature above the expected maximum. Excessive temperatures can damage the filter, the catalyst and the sensors. The control unit usually stops or limits the regeneration to protect the system.
Can I keep driving with code P244D active?
With caution: limp mode possible, have it checked soon
Common causes — P244D
Faulty exhaust temperature sensor or an incorrect reading Too much fuel sent to the exhaust during regeneration (injector or metering problem) Filter heavily loaded with soot burning off violently Damaged or partly melted catalyst or filter Intake air or turbocharger problems that alter combustion Cooling system or EGR faults
How do you fix code P244D?
Avoid heavy loads and long high-speed stretches until the car has been checked. Have the exhaust temperatures read at a workshop and the sensors and regeneration injection verified. If you smell burning or see unusual smoke, stop safely and do not continue driving.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P244C — Exhaust temperature too low for particulate filter...
- Next code: P244E — Exhaust temperature too low for particulate filter...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible