P2456 — Particulate filter pressure sensor A circuit intermittent or erratic
| Meaning | The control unit is receiving a signal from particulate filter pressure sensor A that drops out, jumps or changes for no reason from time to time. The fault comes and goes, so it is often a contact that does not hold properly. In these conditions the control unit cannot always tell how clogged the filter is. |
| Family | Powertrain (P) |
Typical symptoms
Irregular or out of schedule regenerations
Occasional loss of power
Rising fuel consumption
Problem appearing with vibration, rain or after washing the car
Unusual smoke from the exhaust at times
Common causes
Wiring rubbed, damaged or with a nearly broken conductor
Pressure hoses cracked or not fixed properly
Differential pressure sensor that is starting to fail
Moisture or water in the connector
Control unit fault, which is rare
What to do
How to read code P2456
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2456 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (56) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2456 mean?
Particulate filter pressure sensor A circuit intermittent or erratic. The control unit is receiving a signal from particulate filter pressure sensor A that drops out, jumps or changes for no reason from time to time. The fault comes and goes, so it is often a contact that does not hold properly. In these conditions the control unit cannot always tell how clogged the filter is.
Can I keep driving with code P2456 active?
With caution: limp mode possible, have it checked soon
Common causes — P2456
Corroded sensor connector or loose terminals Wiring rubbed, damaged or with a nearly broken conductor Pressure hoses cracked or not fixed properly Differential pressure sensor that is starting to fail Moisture or water in the connector Control unit fault, which is rare
How do you fix code P2456?
First check the connector, wiring and hose fixings of the sensor, moving them with the engine running only in a workshop or with due care. Then have the live value read with the diagnostic tool. It is worth acting fairly promptly, because an unreliable signal can lead to wrong regenerations.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2455 — Particulate filter pressure sensor circuit high
- Next code: P2457 — Exhaust gas recirculation cooling system performan...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible