P245B — EGR cooler bypass status line intermittent
| Meaning | The control unit reads a status or position signal from the EGR cooler bypass, and this signal drops out or changes for no reason from time to time. The fault comes and goes, so it is often a contact that does not hold properly. The exact name and layout of the system can change from manufacturer to manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Occasional loss of power or uneven idle
Problem appearing with vibration, rain or after washing the car
Unusual smoke from the exhaust at times
Rising fuel consumption
Sometimes no obvious symptom
Common causes
Wiring rubbed or with a nearly broken conductor
Bypass actuator position sensor that is starting to fail
Moisture or water in the connector
Bypass actuator mechanically stiff or sticking at times
Control unit fault, which is rare
What to do
How to read code P245B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P245B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (5B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P245B mean?
EGR cooler bypass status line intermittent. The control unit reads a status or position signal from the EGR cooler bypass, and this signal drops out or changes for no reason from time to time. The fault comes and goes, so it is often a contact that does not hold properly. The exact name and layout of the system can change from manufacturer to manufacturer.
Can I keep driving with code P245B active?
With caution: limp mode possible, have it checked soon
Common causes — P245B
Actuator or position sensor connector corroded or with loose terminals Wiring rubbed or with a nearly broken conductor Bypass actuator position sensor that is starting to fail Moisture or water in the connector Bypass actuator mechanically stiff or sticking at times Control unit fault, which is rare
How do you fix code P245B?
First check the connector and wiring of the EGR bypass actuator, looking for signs of moisture or corrosion. Then have the status signal read live at a workshop. It is usually not urgent, but an intermittent fault tends to get worse over time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P245A — EGR cooler bypass control circuit open
- Next code: P245C — EGR cooler bypass control circuit low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible