P2460 — Particulate filter pressure sensor B circuit low
| Meaning | The control unit is receiving a lower than normal voltage from diesel particulate filter (DPF) pressure sensor B. Without this measurement it cannot know how clogged the filter is and cannot manage regenerations properly. The problem is usually in the sensor, the wiring or the hoses. |
| Family | Powertrain (P) |
Typical symptoms
Missed or too frequent regenerations
Loss of power or limp mode
Rising fuel consumption
Unusual smoke from the exhaust
Filter clogging over time without the car warning you properly
Common causes
Wiring shorted to ground or broken
Corroded connector or loose terminals
Pressure hoses disconnected, broken or punctured
Missing sensor supply voltage
Control unit fault, which is rare
What to do
How to read code P2460
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2460 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (60) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2460 mean?
Particulate filter pressure sensor B circuit low. The control unit is receiving a lower than normal voltage from diesel particulate filter (DPF) pressure sensor B. Without this measurement it cannot know how clogged the filter is and cannot manage regenerations properly. The problem is usually in the sensor, the wiring or the hoses.
Can I keep driving with code P2460 active?
With caution: limp mode possible, have it checked soon
Common causes — P2460
Faulty differential pressure sensor Wiring shorted to ground or broken Corroded connector or loose terminals Pressure hoses disconnected, broken or punctured Missing sensor supply voltage Control unit fault, which is rare
How do you fix code P2460?
First check the sensor connector, wiring and hoses. Then have the sensor reading checked at a workshop with the engine off and running. It is worth acting soon, because without a reliable measurement the filter risks clogging.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P245F — Particulate filter pressure sensor B range or perf...
- Next code: P2461 — Particulate filter pressure sensor B circuit high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible