P2464 — Particulate filter differential pressure too low, bank 2
| Meaning | On the second exhaust bank, the control unit sees a pressure difference across the particulate filter that is lower than expected. A value that low can mean the filter is hollowed out, broken or removed, or that the sensor or its hoses are not measuring correctly. Bank 2 only exists on V engines or engines with two separate exhaust lines. |
| Family | Powertrain (P) |
Typical symptoms
Exhaust smoke different from usual, sometimes darker or more visible
Exhaust sound has changed
Often no other obvious driving symptom
Failed emissions inspection
Common causes
Faulty or out-of-range differential pressure sensor
Exhaust leak ahead of the filter
Particulate filter damaged, hollowed out or tampered with
Sensor wiring problem
Rarely, outdated control unit software
What to do
How to read code P2464
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2464 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (64) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2464 mean?
Particulate filter differential pressure too low, bank 2. On the second exhaust bank, the control unit sees a pressure difference across the particulate filter that is lower than expected. A value that low can mean the filter is hollowed out, broken or removed, or that the sensor or its hoses are not measuring correctly. Bank 2 only exists on V engines or engines with two separate exhaust lines.
Can I keep driving with code P2464 active?
With caution: limp mode possible, have it checked soon
Common causes — P2464
Pressure sensing hoses disconnected, split or swapped Faulty or out-of-range differential pressure sensor Exhaust leak ahead of the filter Particulate filter damaged, hollowed out or tampered with Sensor wiring problem Rarely, outdated control unit software
How do you fix code P2464?
Start with the sensor hoses and fittings on bank 2, then look for exhaust leaks. If you suspect the filter has been removed or emptied, it needs a proper check in a workshop. The car usually drives normally, but have it looked at within a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2463 — DPF: excessive soot accumulation
- Next code: P2465 — Particulate filter differential pressure too high,...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible