Skip to content
Fault code dictionary (DTC)

P2470 — Exhaust temperature sensor signal too low, bank 1 sensor 4

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe voltage on the circuit of sensor 4 on bank 1 is lower than normal, as if the sensor were reading a very cold temperature or the wire were shorted to ground. The control unit cannot rely on that reading to manage the particulate filter.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Filter regeneration not carried out or abnormal
Loss of power or limp mode
Higher diesel consumption

Common causes

Sensor wire touching ground
Wet, corroded or damaged connector
Faulty temperature sensor
Wiring crushed or burnt near the exhaust
Rarely, a faulty engine control unit

What to do

Check the sensor wiring and connector on bank 1, looking for moisture, corrosion or damaged insulation. If the filter can't regenerate properly it may clog, so have the system checked without waiting too long. Don't clear the code without repairing the cause.

How to read code P2470

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2470 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (70) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2470 mean?

Exhaust temperature sensor signal too low, bank 1 sensor 4. The voltage on the circuit of sensor 4 on bank 1 is lower than normal, as if the sensor were reading a very cold temperature or the wire were shorted to ground. The control unit cannot rely on that reading to manage the particulate filter.

Can I keep driving with code P2470 active?

With caution: limp mode possible, have it checked soon

Common causes — P2470

Sensor wire touching ground Wet, corroded or damaged connector Faulty temperature sensor Wiring crushed or burnt near the exhaust Rarely, a faulty engine control unit

How do you fix code P2470?

Check the sensor wiring and connector on bank 1, looking for moisture, corrosion or damaged insulation. If the filter can't regenerate properly it may clog, so have the system checked without waiting too long. Don't clear the code without repairing the cause.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes