Skip to content
Fault code dictionary (DTC)

P2498 — EGR cooler bypass position sensor bank 2: reading out of range

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit compared the EGR cooler bypass valve position on bank 2, as read by the sensor, with what it expected, and they do not match. The sensor may be fine while the valve is stuck, or the sensor may be giving a wrong value.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Reduced engine smoothness in some conditions
Increased emissions or smoke
Possible power limitation
No noticeable driving symptom in some cases

Common causes

Coked or stuck bypass valve
Out-of-calibration or faulty position sensor
Worn valve mechanism or actuator
Connector with weak contact
Very dirty EGR cooler

What to do

First have someone check whether the bank 2 bypass valve moves freely and whether the sensor follows its movement. It's best to act soon, since carbon buildup tends to increase.

How to read code P2498

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2498 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (98) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2498 mean?

EGR cooler bypass position sensor bank 2: reading out of range. The control unit compared the EGR cooler bypass valve position on bank 2, as read by the sensor, with what it expected, and they do not match. The sensor may be fine while the valve is stuck, or the sensor may be giving a wrong value.

Can I keep driving with code P2498 active?

With caution: limp mode possible, have it checked soon

Common causes — P2498

Coked or stuck bypass valve Out-of-calibration or faulty position sensor Worn valve mechanism or actuator Connector with weak contact Very dirty EGR cooler

How do you fix code P2498?

First have someone check whether the bank 2 bypass valve moves freely and whether the sensor follows its movement. It's best to act soon, since carbon buildup tends to increase.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes