Skip to content
Fault code dictionary (DTC)

P24A1 — Particulate filter regeneration: temperature too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningDuring the filter cleaning cycle the control module saw a higher temperature than expected and could not bring it back within limits with its corrections. Excessive heat can damage the filter and nearby exhaust parts. The code shows the symptom but does not by itself say which part is responsible.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Possible power limitation by the control module to protect the exhaust
Interrupted or abnormal regenerations
Cooling fan very active
Strong smell or unusual smoke from the exhaust
Higher diesel consumption than normal

Common causes

Exhaust temperature sensor giving wrong readings
Too much fuel injected during regeneration, for example from a faulty injector
Filter with heavy soot load burning too violently
Oxidation catalyst ahead of the filter not working properly
Problem with intake air management or the EGR system
Filter partly damaged or melted

What to do

Have the car checked soon: excessive heat in the exhaust can ruin the filter and damage nearby parts. At the workshop it is best to read the real temperatures and check sensors and injectors before replacing parts. Avoid long hard-loaded drives until it has been checked.

How to read code P24A1

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P24A1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (A1) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P24A1 mean?

Particulate filter regeneration: temperature too high. During the filter cleaning cycle the control module saw a higher temperature than expected and could not bring it back within limits with its corrections. Excessive heat can damage the filter and nearby exhaust parts. The code shows the symptom but does not by itself say which part is responsible.

Can I keep driving with code P24A1 active?

With caution: limp mode possible, have it checked soon

Common causes — P24A1

Exhaust temperature sensor giving wrong readings Too much fuel injected during regeneration, for example from a faulty injector Filter with heavy soot load burning too violently Oxidation catalyst ahead of the filter not working properly Problem with intake air management or the EGR system Filter partly damaged or melted

How do you fix code P24A1?

Have the car checked soon: excessive heat in the exhaust can ruin the filter and damage nearby parts. At the workshop it is best to read the real temperatures and check sensors and injectors before replacing parts. Avoid long hard-loaded drives until it has been checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes