P24A3 — Particulate filter restricted: soot buildup (bank 2)
| Meaning | The control module detected more soot than normal built up in the bank 2 particulate filter, which is restricting exhaust flow. This applies to engines with two exhaust lines, such as V6 and V8 engines. The code alone does not say why the soot built up. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power, especially when accelerating
Regenerations more frequent than usual
Higher diesel consumption
Limp mode with reduced power
Dark smoke or strong smell from the exhaust
Common causes
Filter differential pressure sensor giving wrong readings
Excess soot produced by the engine, for example from faulty injectors
EGR problem increasing particulate production
Exhaust temperature sensors not working properly
Filter damaged or saturated with ash
What to do
How to read code P24A3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24A3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (A3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24A3 mean?
Particulate filter restricted: soot buildup (bank 2). The control module detected more soot than normal built up in the bank 2 particulate filter, which is restricting exhaust flow. This applies to engines with two exhaust lines, such as V6 and V8 engines. The code alone does not say why the soot built up.
Can I keep driving with code P24A3 active?
With caution: limp mode possible, have it checked soon
Common causes — P24A3
Regenerations interrupted or never completed, often from city-only driving Filter differential pressure sensor giving wrong readings Excess soot produced by the engine, for example from faulty injectors EGR problem increasing particulate production Exhaust temperature sensors not working properly Filter damaged or saturated with ash
How do you fix code P24A3?
Do not ignore this code: a heavily clogged filter makes the engine run badly and can become hard to recover. Have the soot load, the pressure sensor and the reason for the buildup checked at a workshop before deciding what to do. In the meantime, when conditions allow, a longer drive at steady speed may help.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24A2 — Particulate filter regeneration incomplete (bank 1...
- Next code: P24A4 — Particulate filter soot load too high (bank 1)
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible