P24AB — EGR cooler coolant pump: stuck on
| Meaning | The control module detected that the EGR cooler coolant pump keeps running even when it should be off. It may come from a command that stays active, a stuck relay, or the pump itself. A pump that is always on wears out sooner and can drain the battery. |
| Family | Powertrain (P) |
Typical symptoms
Pump noise with the engine off
Battery draining faster
Coolant temperature rising less than normal when cold
Cabin heating less effective in the first minutes
EGR managed abnormally
Common causes
Wiring in contact with the supply voltage
Electric pump with faulty internal electronics
Fixed command from the control module due to a driver fault
Corroded connections creating wrong signals
What to do
How to read code P24AB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24AB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (AB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24AB mean?
EGR cooler coolant pump: stuck on. The control module detected that the EGR cooler coolant pump keeps running even when it should be off. It may come from a command that stays active, a stuck relay, or the pump itself. A pump that is always on wears out sooner and can drain the battery.
Can I keep driving with code P24AB active?
With caution: limp mode possible, have it checked soon
Common causes — P24AB
Pump relay stuck closed Wiring in contact with the supply voltage Electric pump with faulty internal electronics Fixed command from the control module due to a driver fault Corroded connections creating wrong signals
How do you fix code P24AB?
Check whether the pump runs even with the key out: if so, the battery is at risk and it is best to act soon. Check the relay first, then the wiring, and finally the pump. If you cannot do it right away, avoid long periods parked with an already weak battery.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24AA — EGR cooler coolant pump: control circuit high
- Next code: P24AC — EGR cooler coolant pump: feedback circuit low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible